This was a switch that got its wires pulled out. I learned how to desolder today in order to remove it from the little switch board and now there's three holes where this used to be. Does this component have a name, because I'm wondering whether I can just get a replacement one like this. There are lots of tools and supplies at the makerspace I used, but I need to know what I'd be looking for.
Alternatively, what else might I be able to use to do this? I suppose I could just trim and strip the wires and shove those through and solder, but that seems...crude? I don't know. I'd prefer something with pins because I practiced soldering and desoldering using some broken electronics I had, and I'm more confident with pins than something so freeform.
Thanks for your time.
This checks out. Even with all of my storage and shelving, I have found the floor to be a nice place to go parts shopping. JST bits are at the top of the list to find, usually. (What was that? You never bought any? You'll find some, don't worry.)
Do you need a bit of wire to patch a trace? Take your shoes off and walk around a bit and you will immediately find a lead you clipped off a through-hole component in about 15 seconds, even though you vacuumed 6 times since you lost it.