this post was submitted on 24 Oct 2023
36 points (95.0% liked)
Linux
48062 readers
879 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Right that is pretty much clear, but I want this exit node to be running ProtonVPN as well. This however does not seem to be possible (to my knowledge). Edit: This is also why Tailscale added support for Mullvad VPN i assume.
Ok... I think I didn't get what you're trying to say. Do you wanna run a VPN through a VPN?
I mean, you have your RPI 4b as a Tailscale exit node, but the RPI 4b itself connects to the ProtonVPN?
Right, so I've got Alpine on the RPI, and have installed/configured protonvpn with wireguard. However, if I then start Tailscale, the already running ProtonVPN connection goes down. Same happens if Tailscale is already running, and I try to start the ProtonVPN connection it will just refuse the connection.
I want it to connect to both services, as then this can act as the exitnode for all other devices on the tailnet. Whilst also giving the benefit of ""being in a different location"" with protonvpn.
So essentially, both services wants to use /dev/net/tun, but only one can.
Well, I found this article saying that theoretically is possible, however not so much. It says that depends on how the other VPN works. They even suggest some workarounds, so take a look
Anyway, have you tried to create another tun/tap service to run both VPN?
Yeah already scoured their documentation for this, but no luck with any of the workarounds sadly.
Have not tried to do the latter you mentioned though? Not sure how to do that, but I will look into it asap.
I never had to create a new TUN/TAP interface before, so I'm on the same boat as you. I'm brainstorming here with you and hoping for the best
But here is how to create a new tun interface:
https://www.baeldung.com/linux/create-check-network-interfaces
You'll have to manually set some parameters to make it work, I guess