this post was submitted on 16 Jun 2023
627 points (100.0% liked)
Technology
37747 readers
222 users here now
A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.
Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.
Subcommunities on Beehaw:
This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I had a Sony Xperia Z3 which had its charging port and sim tray covered by small pieces attached to the case that had rubber on them so you could open it and use the port and then seal it again. It also had a magnetic charging port that didn't need water protection.
But iirc, it was said that the waterproof rating was only true as long as you didn't use these pieces^^
I can think of a design where the battery just sits tight against the top part of the smartphone and you could remove the bottom part to spring it out like an SD-Card. That bottom part would just need to have rubber on the inside edges