danhasnolife

Looks our first post-phyrexian palette cleanser leans into magical and the fairy tale. Not sure how I feel about this endless sleep threat, but we'll see how it plays out.

This is an absolutely spectacular long form article from NYT that walks through small communities in mesopotamia, and how large political and economic changes have made them among the first to experience climate change as a life-threatening crisis. It also foreshadows water wars and how they could increasingly become a part of our political climate.

For transparency, I only signed up for a Discover card recently because they had a 15 month 0% balance transfer promotion, which is what I've been looking for. In general it's seemed like their rewards were not outstanding and you had to deal with potentially not having the card accepted elsewhere.

My receiving bank botched the transfer and the funds were missing for a bit. Discover was excellent -- every time I called there was a minimal wait for a U.S. based customer support agent that I could understand clearly and was knowledgeable about the situation. I was surprised.

I get that you may go years without ever needing to contact support, but it definitely quickly made a difference for me.

Hi all,

First, I understand that neither is the optimal solution. I live in an 1800's farmhouse with plaster-and-lathe walls on top of a three-feet-deep stone foundation. Additionally, the exterior walls are too thin for a traditional outlet and require special retrofitting. I can say all of this with certainty because we discovered all of this while renovating our kitchen and bringing items up to code. To install to-code outlets, we needed to temporarily remove baseboard heating systems, drill through 9" deep hardwood floors, and then angle 90' from the floor into the wall underneath the pex heating cable in order to access the wall, using shallow receptacles to fit.

We simply don't have the funds to do this with all portions of this old house, at least not now. For our window-unit air conditioners (1 12,000 BTU Midea U inverter, 2 older 8000 BTU ACs), we do not have a modern grounded outlet within reach of our AC cable. Recognizing that neither option is ideal, what is safer:

a) Use a 'heavy-duty' short extension cord to bridge the gap between grounded outlet and AC power cable, and then tie the cable to prevent physical tripping or loosening

OR

b) Use a legitimate higher-end surge protector like a Tripp-Lite to extend outlet reach and plug into the surge protector.

Additionally, I would appreciate any general advice on the order of operations in the house as we slowly build towards an up-to-code century home. Our priorities are loosely in this order:

New panel, upgrading to 200a with whole home surge protector and dedicated grounds - DONE

Upgraded kitchen to modern code - IN PROGRESS

Replace all loose 2-prong outlets with GFCI, using "no equipment ground"

Re-order circuits that don't make sense

Add additional outlets -- potentially using wire mold to avoid digging into lathe based on expense.

Thoughts? Do you think these will allow some new decks to rise in viability?

Honestly a little surprised that WoTC didn't intentionally delay printing this card for longer. I'm not sure everyone even has their full inventory yet.