this post was submitted on 26 Jun 2024
1726 points (99.1% liked)
Science Memes
11004 readers
3011 users here now
Welcome to c/science_memes @ Mander.xyz!
A place for majestic STEMLORD peacocking, as well as memes about the realities of working in a lab.
Rules
- Don't throw mud. Behave like an intellectual and remember the human.
- Keep it rooted (on topic).
- No spam.
- Infographics welcome, get schooled.
This is a science community. We use the Dawkins definition of meme.
Research Committee
Other Mander Communities
Science and Research
Biology and Life Sciences
- !abiogenesis@mander.xyz
- !animal-behavior@mander.xyz
- !anthropology@mander.xyz
- !arachnology@mander.xyz
- !balconygardening@slrpnk.net
- !biodiversity@mander.xyz
- !biology@mander.xyz
- !biophysics@mander.xyz
- !botany@mander.xyz
- !ecology@mander.xyz
- !entomology@mander.xyz
- !fermentation@mander.xyz
- !herpetology@mander.xyz
- !houseplants@mander.xyz
- !medicine@mander.xyz
- !microscopy@mander.xyz
- !mycology@mander.xyz
- !nudibranchs@mander.xyz
- !nutrition@mander.xyz
- !palaeoecology@mander.xyz
- !palaeontology@mander.xyz
- !photosynthesis@mander.xyz
- !plantid@mander.xyz
- !plants@mander.xyz
- !reptiles and amphibians@mander.xyz
Physical Sciences
- !astronomy@mander.xyz
- !chemistry@mander.xyz
- !earthscience@mander.xyz
- !geography@mander.xyz
- !geospatial@mander.xyz
- !nuclear@mander.xyz
- !physics@mander.xyz
- !quantum-computing@mander.xyz
- !spectroscopy@mander.xyz
Humanities and Social Sciences
Practical and Applied Sciences
- !exercise-and sports-science@mander.xyz
- !gardening@mander.xyz
- !self sufficiency@mander.xyz
- !soilscience@slrpnk.net
- !terrariums@mander.xyz
- !timelapse@mander.xyz
Memes
Miscellaneous
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The wheels are attached to the plane so they move at the same time as the plane. But, I get what you're trying to say, that the wheels are effectively being dragged by the plane, they're not powering the movement. But, what you need to think about is that if you oppose that dragging by moving the conveyor belt in the opposite direction you can prevent the plane from moving at all. Yes, the wheels are merely dragging and there isn't a lot of friction there, but friction increases with speed. And, if you move the conveyor belt fast enough, you can stop the plane from moving relative to the ground, which can stop it from moving relative to the air, which can prevent it from taking off.
No, by definition it's the same. The conveyor moves with however much speed is necessary to stop the forward motion of the plane. The conveyor would eventually go so fast that it generated enough force to stop the plane from moving, so it's indistinguishable from an anchor.
You don't need to deflate the tires, you merely need to increase the speed at which the conveyor moves to match the speed of the wheels.
That seems like an unfair assumption because you're assuming that the conveyor belt has second-order effects on the air (i.e. generating a "wind" over the wings of the plane), while ignoring the second-order effects the conveyor would have on the wheels (massive heat from friction leading to failure).
I mean, the discussion is of a plane, not a helicopter or a rocket. Even jet fighters with a thrust-to-weight ratio of more than 1 typically have engines that only have that ratio once they're at high speed, not from a standing start. That's why even fighter jets on carriers need a catapult-assisted takeoff. A VTOL aircraft like a Harrier wouldn't need that, but then its takeoff speed is zero, and the myth isn't very interesting when the conveyor belt doesn't move.
no. I'm saying that by the time the wheel is rolling, the plane's is already moving forward, the engines have already overcome the drag in the wheels. the treadmill is locked to the wheels, not the plane. The plane would continue accelerating even as the wheels reported weird rates of turning.
As for the (very brief) time delay, that's a function of the plane's gear's suspension that is quite well sprung.
the rate of roll on the tire is, effectively, decoupled from the airspeed (and groundspeed) of the plane. which makes this:
... entirely different. an affixed anchor does not allow the free motion that a wheel would.
And one of a few things happen. Either the plane has enough engine thrust to overcome the acceleration induced by the wheels, and therefore takes off, or it does not.
In the case that it does not, the wheels would continue spinning in increasing RPM until the plane begins moving backwards. because, again, the airspeed of the airplane is not dependent on the wheel's RPM. Assuming the airplane doesn't crash from suddenly becoming incredibly difficult to control.. eventually it would take off anyhow. because the airflow over the wings would still generate lift. (though they would become horribly inefficient.) and therefore take off.
this is of course ignoring the whole "can a pilot actually control that and manage a take off like that" thing. If you don't want to grant godlike piloting skills, we could then just make the treadmill irrelevant and leave the brakes on.
The wheels are attached to the plane, so they move at the same time. There's going to be slight flex due to rubber and metal not being insanely stiff, but essentially as soon as the plane starts moving forward through the air, the wheels start rolling forward along the ground. Since the conveyor belt cancels the forward movement of the wheels, the movement of the plane ceases too.
Initially, for a few tenths of a second, or a few seconds sure. But, during that time, the conveyor belt would be moving faster and faster as it matched the speed of the wheels. The faster the conveyor moved, the more friction there would be, and the more drag there would be from that friction. Eventually you'd reach an equilibrium where the drag from the wheels was equal to the thrust from the engine, and the plane would cease moving forward. It would be exactly like the plane being anchored to the ground, except instead of a stationary anchor, the anchor would be a spinning treadmill in contact with a spinning wheel. In a world without a magic conveyor belt that could instantly adjust to the speed of the wheels, there would be some slight forward and backward movement of the plane, but that's just like being attached to an anchor with a bungee rather than a rigid rope.
The wheel doesn't have free motion. By definition, the conveyor is moving at the same speed as the wheel, so the wheel is locked in place. With a real conveyor belt there would of course be some lag as the motors of the conveyor accelerated the belt, but using the hypothetical as defined, the axle of the wheel couldn't ever move because every rotation of the wheel would be matched by a movement of the conveyor belt.
The thrust would have to be infinite because, by definition, the conveyor is always going to match the velocity of the wheels. If the wheels were truly frictionless, then the conveyor belt would have no effect at all. But, any real wheel will have some friction that will increase with speed, so there will always be some speed where the force backwards from the friction of the spinning wheels matches the force of the engine.
As an aside, my guess is that most real airplane wheels would probably fail pretty quickly at just double the normal takeoff / landing speed. The centripetal force acting on the spinning parts of the wheel and tire increase with the square of the velocity, so 2x as fast means 4x as much force. 3x as fast and 9x as much force. So, if you did this with a real wheel, you'd destroy the wheel pretty quickly. Of course, the same applies to the conveyor belt, but I'm going to assume that it's specially engineered to survive this challenge.
The plane wouldn't move backwards because if the wheels slowed down, the conveyor belt would slow down too. Of course, that's in a world where the conveyor belt could adjust its velocity instantaneously, but for this thought-experiment you can say that if the pilot cuts the engine or something, the wheels don't spin as fast, so the conveyor belt slows down, and the plane remains in one spot.
In the thought-experiment world, there wouldn't be any airflow over the wings because the plane would be stationary. In reality, there would be some airflow due to the movement of the conveyor belt, but the wheels would probably melt long before that was enough air to give the plane lift while stationary relative to the world around.