this post was submitted on 06 May 2024
71 points (97.3% liked)
Linux
47952 readers
1632 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Navigating the various things podman/docker allocate can be a bit annoying. The cli tools don't make it terribly obvious either.
You can try using
docker volume rm name
to remove them. It may tell you they're in use and then you'll need to find the container using them.Does all this also apply to distrobox? I don't use podman, but I do use distrobox, which I think is a front-end for it, but I don't know if the commands listed here would be the same.
I'm not terribly familiar with distrobox unfortunately. If it's a front end for podman then you can probably use the podman commands to clean up after it? Not sure if that's the "correct" way to do it though.