3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
It's been a while since I last printed TPU.
I think I've always had to set a slightly higher flow rate for TPU, probably because it always compresses a bit when pushed by the extruder.
My TPU roll printed somewhat colder than yours at about 220C.
I usually start with a very low speed (15-30mm/s), retraction completely off, cooling fan very low (25%).
Tune the flow rate and speed then add a tiny amount of retraction (<1mm).
YMMV
I completely forgot about flow rate, increasing that completely fixed the issue. Thanks!
Great! Good to hear.
Don't forget to turn it back down with less springy filaments.
I have seperste filament profiles for everything, so these changes only affected my "TPU 85A" profile
I always kinda hated printing with TPU, it was am absolute nightmare on my old printrbot.
It's much less so on my prusa, but I'm still used to avoiding it whenever I can.