this post was submitted on 26 Aug 2023
846 points (94.1% liked)
Technology
59414 readers
3119 users here now
This is a most excellent place for technology news and articles.
Our Rules
- Follow the lemmy.world rules.
- Only tech related content.
- Be excellent to each another!
- Mod approved content bots can post up to 10 articles per day.
- Threads asking for personal tech support may be deleted.
- Politics threads may be removed.
- No memes allowed as posts, OK to post as comments.
- Only approved bots from the list below, to ask if your bot can be added please contact us.
- Check for duplicates before posting, duplicates may be removed
Approved Bots
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Bilateral tolerancing is a Machinist's first introduction to tolerancing so it's no surprise to run that as default. And I suppose GD&T is not heavily used where you are.
If you're given a parallelism tolerance of 10 micron are you assuming that to be +-10 micron? True position? Angularity of 5 thou? Etc... The only feature control that could be interpreted as bilateral by default is profile and it's still communicated by its total tolerance.
Simple +- tolerancing isn't the industry standard anymore. And if Tesla prints are anything like spaceX ones... It's basically all GD&T and minimal title block tolerances.
I use GD&T on all my drawings, including 100% of my hole callouts. However I'm one of the more enthusiastic adopters of ASME Y14.5 at the place I work. Therefore, I get what your saying regarding the tolerance range, but since most of my coworkers are still relying on block tolerances, I'll refer to a .010" positional tolerance as a "+/- .005" equivalent" in conversation so there is no miscommunication. I can see how this is not the norm.