I was lucky to spend 4 beautiful years with a Creality Ender 3 v2 that I modded to the brim and never failed to deliver quality prints. I never had to adjust, calibrate or tweak anything regarding print quality.
I upgraded today to a Sovol SV-08 because despite its qualities, the Ender 3 is too small and slow for my current needs.
However, the print quality is definitely not there (yet). Overhang quality is bad but I think I may be able to tweak it with filament temp and/or cooling. There's a bit of ringing but I can live with it. My main issues are the large holes in the hull.
Filament: Overture black PETG, 240°C, 24min print.
What should I try?
Thanks
Edit: most issues were solved by doing the following adjustments:
- PETG temperature increased to 245
- volumetric flow reduced from 17mm^3/s to 10mm^3/s
- manually adjusting z-offset with the paper sheet method like on my old Ender3
There are still minor issues like overhang drooping and adhesion needs a bit more work but quality is now almost on par with my previous printer.
Thanks to everyone !
I've definitely noticed less shininess than the same filament was getting at the same temperatures on my previous printer, except for the first layer. As the first layer prints without part cooling, my guess is that the extra part cooling versus the other printer means it's setting before it's had time to self-level. If that's right, then turning down the part cooling (and then also the speed so you can get away with the reduced part cooling) would make things shiny again. I've not bothered investigating that, as most of what I print is either functional, where I wouldn't care about shininess, or gets painted, where any shininess would come from paint or clearcoat.