whodovoodoowedo

joined 1 year ago
sorted by: new top controversial old
How much do Americans actually pay for healthcare? in c/asklemmy@lemmy.world
[–] whodovoodoowedo@lemmy.world 2 points 2 months ago (1 children)

Do you only have to pay the 10.000 and everything is covered or is there still more to pay per visit or procedure?

How much do Americans actually pay for healthcare? in c/asklemmy@lemmy.world
[–] whodovoodoowedo@lemmy.world 9 points 3 months ago (3 children)

I started a new job this week, in the US, and for a family of four I'm going to pay $30,000 per year in premiums....only premiums.

IBM Buys HashiCorp To Control The Alternative To Red Hat Kubernetes in c/technology@lemmy.world
[–] whodovoodoowedo@lemmy.world 12 points 6 months ago (7 children)

Yea, I am very confused by the headline. Maybe if it compared Openshift to Kubernetes...

Hashicorp signs agreement to be acquired by IBM in c/technology@lemmy.world
[–] whodovoodoowedo@lemmy.world 9 points 6 months ago

hashicorp's APIs will be right at home at IBM. Right along with HCL. not a fan of either but have been forced to use them. this might bode well for my future if a pending license change is coming.

A Huge Number of Homeowners Have Mortgage Rates Too Good to Give Up in c/news@lemmy.world
[–] whodovoodoowedo@lemmy.world 11 points 7 months ago (1 children)

a fellow texan?

8
How can I select Slot 1 when sending to printer? (imgur.com)
submitted 1 year ago* (last edited 1 year ago) by whodovoodoowedo@lemmy.world to c/3dprinting@lemmy.world
1 comments fedilink
 

Screenshots: https://imgur.com/a/jp5fm3U

Slot 1 is loaded with Bambu Labs Aero PLA. Slot 3 is loaded with support material for PLA. No issue loading and they are recognized correctly by the printer. I do a resync in Bambu studio and the results are the same as before the resync (and they are correct).

I have tried saving the slice, quitting Bambu Studio, turning off printer, turning on printer, loading Bambu Studio, and then replacing and end up at the same spot needing to select the slot that has Aero PLA.

Anyone know how to get around this?