Just answer them with a little explanation like you did here, you will be fine. Done that, been there.
They just want to protect against people buying lots of servers for a short time, then not paying or doing ddos shit.
toma
joined 1 year ago
Make sure you are not an open relay.
If you also sent mail, make sure you have setup dkim and spf and dmarc
Check if the router has the possibility to isolate the lan port. That way the port on the router can not talk to other devices in different ports or wlan.
Second possibility is to check if the router supports VLAN. If so you can put the TV or a port on a separate VLAN.
If all that is not possible, consider removing the cable and connect the tv wireless. That way you can put the tv on the guest WiFi network. That should come with isolation by default.
If you don’t want that either, you can resort to extra hardware. Any device with two lan ports could do. Make one port a dhcp based wan port connected to the current network and the other port goes to the tv. Run a dhcp server and nat and you have the tv isolated.
You can use Bind or any other nameserver-server.
But this is one of the things you might want to reconsider. Setup errors might slip in silently and might be hard to diagnose. Complying to the standards like DNSSec and IPv6 on the nameserver might be a challenge without experience.
Next to that, you probably can’t register the domain itself without a third party, and I always advice to not use a different party for nameservers than the party that registered the domain.
Laat point I want to bring up, I would advise against combining name servers with other services, as it is crucial for operating the services, you are creating one giant point of failure. Keep it separated. Seperate hardware
That said, if you accept all these dangers, it’s technically doable. Open the right ports, configure the zone, setup master and slave, read up on glue records, register the name server if needed, setup DNSSec and set the correct name servers in the domain at the party you registered the domain.
I’ll give you a pointer, the rest is up to you how to apply that in LXC
https://www.cyberciti.biz/faq/howto-get-linux-static-dhcp-address/
You probably tried to do to much in one day :)
Netatmo has a delay indeed. There is an option to get a developer account at Netatmo so changes get pushed to HA. But still, it has some quirks.
Advice is to work on one integration at a time, read the documentation, search for your problems. After the integration works, setup your dashboard. After that start with the automatons.
Good luck, HA it’s really worth it, invest a bit more time in it.
You can look at backuppc, it has served us well for years now. Offsite, manages incremental and full back ups, file deduplication, etc.
So on your Minecraft server do a daily backup and add the day off the week to it (whatever.7.gz), this way you always have 7 backups on the server and it auto rotates.
Add that for folder to backuppc and the backup server will automatically decrease the amount of backups if they get older.
You can run Lemmy private, without any federation.
If you are looking for something facebookish, than you could look at WordPress with BuddyPress plugins for example.
Solved in 0.18
I had very similar wishes, but settled on a Velica (GL-B2200). It comes with OpenWRT out of the box, and can be flashed to the newest version. It has great WiFi coverage, which is nicer than top speed imho. Downside is only 1 wan and 1 lan, but with a VLAN and a separate switch it might be ok for you.