Going to be targeting striped bass, and didn’t want to mess with bait. Swapped out the hooks on the Cleos to barbless, and crimped down barbs on the other two. 
Sweet, Nitecore! They seem to make great stuff.
jwigum
joined 1 year ago
https://www.apple.com/iphone/compare/?modelList=iphone-SE,iphone-SE-3rd-gen
For 10mm difference on the height and width, it’s time to buy her a new iPhone as well. It’ll run the latest software, and have much better battery life than her worn battery.
I’m not real familiar with it, but you might look for some chain with a width wider than one link. Seems like that would provide you behavior more similar to belts. It seems McMaster sells double link width, but there may be other sources of finer/wider variations.
Finally, someone mentioning the water usage aspect for a plant being built in Arizona. A water intensive/critical process? Sure, set it up in a desert…
He’s using the first definition of application, you’re using the third: https://www.merriam-webster.com/dictionary/application
Seems you’re running into an issue with a specific hardware config, and people are trying to help you back into solutions for the issues you’re having (pictures of prints, recommending known good/workable hardware configs, etc.). That’s pretty nice, but you seem to be chafing at the perception they aren’t giving you exactly what you want. Slicer profiles can be really detailed, so you’ll have to be specific about what information you need/want. “Give me everything” isn’t going to do it. The requests to look at example prints make me think people either aren’t confident they can trust your descriptions, or they don’t have the hardware you’re using (but still want to help). It might also just be a community requirement to make sure there’s actionable data in an ask to the group.
There seem to be some resources out there for what you’re asking:
https://3dprintbeginner.com/how-to-install-klipper-on-creality-ender-6/
https://3dpandme.com/2022/10/02/tutorial-btt-manta-m8p-cb1-klipper-guide/
https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-manta-m8p-v1.1.cfg
Based on some of your comments, I figure you’ve probably already found some of the above. If not, I’d give them a look. Good luck!
Curtains don’t close flush around a post? The EDC27 clip for the save!
Shouldn’t use Watterson’s work. He fought long and hard against stuff like this…