dsco

I see this sentiment parroted in every post about guns, and I get it: Some people have never been in a situation that required one, and they don't understand why people would need one.

What I don't get is what it's contributing to the conversation.

They stopped being good cars in 2004. Twenty years they've been shit, and people are still swallowing the gravy.

I used picknbuy24 to get a Nissan Tiida for $1200 USD with like 25k miles. Parts are normally the same as they are on already imported models.

Armachillo from Duluth Trading Co. A bit too tight around the waist after I gained about 10lbs for a medium, but best I've owned so far. They stay up, elastic doesn't wear out, the colors don't fade, and they don't trap a ton of heat.

Journalistic integrity doesn't pay the yacht club dues, Lawrence.

Can you dig it out of the trash? If it's wall-side it can normally be repaired.

I believe they were asking for the Obama-Biden bromance memes.

I got a Chihuahua instead. If it's something out of the ordinary, she'll bark. Oh, she will certainly bark.

Is it just the frayed wires that's causing the issue? Did they short together to destroy the charger?

That's true, but they use nonstandard voltages on their chargers, and it can be tough to find an aftermarket that matches both the voltage and current of stock. Then you run into the "Dell has detected a non-Dell charger" scenario.

Check out thingiverse or printables for free stuff to print. There's so much to make!!!

Also, I've messed with Wanhao printers, and the slicer profiles were not great and did require a lot of fine-tuning. New printers either come with their own slicers or a Cura profile.