Prismo
Does mean that the unvaccinated anti-vaxers will keep away from the vaccinated??
At least one cat 6 ethernet in each room. Multiple outlets in any media room. One of my old houses had speaker jacks in each corner of the room which was a godsend when setting up surround sound for a home cinema setup.
Copse was my initial thought, but there is also the word Spinney.
Puttanesca or risotto. Both relatively easy to make, tale about 40 mins and are delicious!
I guess I’ve been looking at it wrong the whole time! Although, living in the countryside would be preferable for moustache-rainwater
I appreciate the usefulness of my eyebrows to divert rain away from my eyes. I do not appreciate my moustache’s water gathering properties when walking in humid environments.
Surprisingly this chair has come out highly in reviews when compared to 4 figure chairs. I have it and can say it is very comfortable. It’s not going to be the best of the best, however if your budget doesn’t stretch to more than mid-3 figures this could be a good alternative.
https://www.ikea.com/gb/en/p/markus-office-chair-vissle-dark-grey-30261152/
I’m pretty sure I’d be ok in multiple realities
https://i.imgur.com/yzJg1ne.jpg
https://i.imgur.com/IgVP7Fj.jpg
Any ideas on this new issue only affecting one of my printers, only seems to be on the bottom layers of a base mode print. The layers that are not done as one continuous spiral. Photos are before and after, ignore the banding on the before! (Thats another issue I have fixed)
Can’t figure this one out, driving me mad as I have orders to fulfil
Solved:
So a combination of three changes finally got me back the correct result.
- Changed the nozzle for a brand new one, that helped a lot but still had a fee issues.
- Remeasured my extrusion amount and recalibrated the e-steps, they had gone quite a way out.
- Reduced the temp by 10°C apart from the first layer.
I added some swear words as contact names, this is one way to get around the fucking censorship