MeatballFlag

joined 1 year ago
[–] MeatballFlag@lemmy.sdf.org 3 points 1 year ago (1 children)

As per usual, the fine becomes simply the cost of doing business

[–] MeatballFlag@lemmy.sdf.org 2 points 1 year ago (1 children)

Cars don't cease to function when driven in areas with little to no cell reception...

[–] MeatballFlag@lemmy.sdf.org 4 points 1 year ago (3 children)

Because some areas have poor to no cell reception

[–] MeatballFlag@lemmy.sdf.org 15 points 1 year ago (1 children)

I'm sure this will about as effective as D. A. R. E. in American schools and keeping people off drugs

[–] MeatballFlag@lemmy.sdf.org 2 points 1 year ago (1 children)

Maybe because I didn't know what I was doing back then but that was the only way I used Limewire

[–] MeatballFlag@lemmy.sdf.org 3 points 1 year ago (2 children)

Fucking studfinders man...

[–] MeatballFlag@lemmy.sdf.org 1 points 1 year ago

I hate the ea launcher with such a burning passion as to outshine the sun. ~80% it causes a problem launching a game for me and provides zero benefits for it's use. It has no consumer friendly reason to exist

[–] MeatballFlag@lemmy.sdf.org 2 points 1 year ago (1 children)

Thanks I'll give some of these suggestions a try. I am printing with PLA at the same temps I've used in the past with the same material. I wouldn't think the change to pei would require a changing of print temp but I'll keep that in mind as well.

 

This print started fine the first handful of layers before I walked away. I came back later and everyone of these blocks was curling up with the corners lifting off the bed. I just put on the PEI plate, this is the first print on it. I did level the print bed manually with a sheet of paper, the first layers of each block looked nice and uniform. I'm printing with the bed at 60c which is what I've always used with the flexible magnetic print mat that came on the printer. Should I be turning down the bed temp with the PEI plate?

Thanks for any advice

[–] MeatballFlag@lemmy.sdf.org 4 points 1 year ago (4 children)

Rather than setting up a VPS like some of you is there a reason I couldn't run this on my existing home unraid server?

[–] MeatballFlag@lemmy.sdf.org 1 points 1 year ago

Kingroon KP3S here. Totally stock. No issues with it, always had good quality from it out of the box. I want to add a touch sensor and klipper to it but haven't had the time to figure it out