You can really see the difference few inches in
If it's stupid but it works it ain't stupid
this post was submitted on 25 May 2024
64 points (100.0% liked)
Machinist
669 readers
1 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 1 year ago
MODERATORS
Just dont accidentally get ur cutting fluid on the boards it will cause them to be extra frictiony and well now u have an industrial vibrator
Anything is a vibrator if you're brave enough
For when you leave your shop on silent.
I sprayed in some coolant and they didn't seem to stick any more then before, they just rock back and forth
Modulating your feed and speed helps, can find a sweet spot, cutting depth right? is this a very hard material or something.
Who cares. Wood block work.
But we would expect it to change the further in you go regardless of the wood, since it gets more and more rigid.
Yes but if you look at the front of the piece you can see the vibration was cut down dramatically
"It's not ugly, it's effective."
One? No, two? No, 3? No, big block? Yes
First of all, this should have been s gif, you have deprived us of seconds of opportunity joy!
Second of all, save on wood by telling the new guy to sit in it and antivibrate.
(But do not film, I wanna see one of those videos.)
Third of all - you have a pair of square steel nuts, hehehe (cubed screw heads doesn't sound right/poetic enough).
a yes, the ~~tuned~~ mass damper.
De-vibe bars work in a... uh.. similar manner.
Are you not worried that a block of wood is flying through your workshop?
nah it was about 80 rpm if I remember correctly