Mechanical Keyboards

8825 readers

3 users here now

Are you addicted to the clicking sounds of your beautiful and impressive mechanical keyboard?
If so, this community is for you!

Here you can discuss everything about mechanical keyboards (and only mechanical keyboards).

Banner by Jay Zhang on Unsplash

founded 4 years ago

My daily (lower) (infosec.pub)

submitted 1 year ago by 01189998819991197253@infosec.pub to c/mechanicalkeyboards@lemmy.ml

8 comments fedilink hide all child comments

My daily is the kb below. Keychron C1, Fekker Panda switches, foam mod, o-rings, GSA keycaps.

Nothing special, but a very pleasant typing experience.

The above kb is a Moergo Glove80. I'm still getting used to it, so it's not my daily.

top 8 comments

sorted by: hot top controversial new old

[–] AusatKeyboardPremi@lemmy.world 2 points 1 year ago (1 children)

How’s your experience with Glove80?

I am unsure of using low profile switches and keycaps. One of the driving reasons being I would be unable to use my existing keycap sets and switches.

Does the use of low profile switches translate well to a split keyboard?

[–] 01189998819991197253@infosec.pub 1 points 1 year ago (1 children)

I generally only use a computer (and, therefore, a physical keyboard) for work. Since I can't constantly allow myself to be super slow at typing, my advancement with the G80 has been slow going. However, because the travel is super short when compared to standard switches, I can tell that I'm typing faster than I would have had it used mx. I am still bummed I can't use my current caps, but am no longer bummed at the switch incompatibility. I have seen 3D printed converters to allow the use of mx caps on the chocc switches, but really want to get used to the G80 stock before modifying anything.

[–] AusatKeyboardPremi@lemmy.world 2 points 1 year ago (1 children)

That’s interesting. Do you think using converters on choc switches would hamper their durability? Or is the impact negligible?

[–] 01189998819991197253@infosec.pub 2 points 1 year ago (1 children)

I wouldn't imagine it would harm anything if we're not rough with pulling them off. Just being on there shouldn't do any damage. I hope not, because I do plan to get some once I'm used to stock.

[–] AusatKeyboardPremi@lemmy.world 2 points 1 year ago (1 children)

Got it. Do share your experience here after using it. :-)

[–] 01189998819991197253@infosec.pub 2 points 1 year ago

I plan to! It'll likely be a while at my current pace before I get used to it enough to have an opinion other than "it's different", but I will make sure to pose here!

[–] kehalo@lemmy.ml 1 points 1 year ago (1 children)

How do you feel about the Keychron build quality? I just ordered one of the Q5 Pros to have a hotswap/knob board.

Really wanted to snag a Wind x98 kit awhile back, but didn’t have the money (or time) to get one of the kits.

[–] dnzm@lemmy.ml 1 points 1 year ago

Not OP, but I doubt their board's build quality is indicative, really. The C and non-pro K series are wholly like different boards, at a different price point. All plastic, and while they're sturdy enough, it's nothing special.

Source: I have a K2. Compared to my wife's Epomaker TH80, I prefer the Epomaker in terms of build. But it's not like the K2 is bad, or anything. I'd expect the C series to be mostly comparable.