Ikea switch firmware not updating : homeassistant

[+] looping@lemmy.world 2 points 1 year ago* (last edited 1 year ago) (1 children)

[deleted]

[–] Oliper202020@lemmy.world 1 points 1 year ago (1 children)

Here are my logs from what i can tell nothing is wrong in there it doesn't even give me a percentage

[–] finn_der_mensch@discuss.tchncs.de 2 points 1 year ago (3 children)

In those logs it states 'available' as if the update if found but not triggered. Did you send a manual trigger message like described here in the docs? Neither is "Device didn't respond to OTA request" in the log, further suggesting that. Sadly the file is cut off in your screenshot though so it's hard to tell. Could you upload and share the complete log?

[–] Oliper202020@lemmy.world 1 points 1 year ago

I went in to the Z2M OTA menu and it had an update(i just got the switch) and it just didn't show anything about it updating even after a while, so I pressed it again and it just said that it was already updating, so i waited a while more and still nothing pressed it again and it didn't say anything so I waited a bit and then restarted home assistant, but it was just the same, i dont know how to send a manual trigger message, and didn't see anything about it when i skimmed the link you sent, i dont know how to upload the logs

[–] Oliper202020@lemmy.world 1 points 1 year ago (1 children)

Here are my Z2M logs

[–] finn_der_mensch@discuss.tchncs.de 1 points 1 year ago

So apparently my suggestion was wrong and the update request is sent, it is just not received properly. You said you also tried pressing the ikea button meanwhile to prevent it from going to sleep mode, so I'm kinda clueless here too. Maybe it helps to re-pair the switches? or just waiting for the update to be loaded by the switches themselves, which can take some days. zigbee2mqtt seems at least otherwise correctly configured to serve an ota update.

[–] Oliper202020@lemmy.world 0 points 1 year ago

I went in to the Z2M OTA menu and it had an update(i just got the switch) and it just didn't show anything about it updating even after a while, so I pressed it again and it just said that it was already updating, so i waited a while more and still nothing pressed it again and it didn't say anything so I waited a bit and then restarted home assistant, but it was just the same, i dont know how to send a manual trigger message, and didn't see anything about it when i skimmed the link you sent, i dont know how to upload the logs

[+] looping@lemmy.world 2 points 1 year ago* (last edited 1 year ago) (1 children)

[deleted]

[–] Oliper202020@lemmy.world 1 points 1 year ago

I have home assistant running dirrectly on a rpi, but will probably soon move it to a vm

[–] CmdrShepard@lemmy.one 1 points 1 year ago* (last edited 1 year ago)

I just updated my on/off switches and fyrtur shades last week (also running on a Pi). For the switches, I clicked a button on them yo make sure they were awake and then ran to my computer to initiate the update immediately and it worked. The "update initiated pass/fail" message should appear in a small pop-up card on the upper right of the Z2M window before disappearing a few seconds later.

What I haven't been able to update is the open/close switches no matter what I've tried.

[+] looping@lemmy.world 1 points 1 year ago* (last edited 1 year ago)

[deleted]

[+] looping@lemmy.world 1 points 1 year ago* (last edited 1 year ago)

[deleted]