I’ve got an Odroid HC4, comes in a toaster-like enclosure with two SATA ports. Quad-core, 4gb RAM. Works well if you want something fairly simple.
this post was submitted on 22 Oct 2023
35 points (94.9% liked)
Single Board Computers
1264 readers
116 users here now
A community for the discussion of all single board computers. Raspberry Pi is ok, but there are so many other boards now that get looked over that deserve attention.
Post news, questions, your setups, guides, anything that has to do with SBCs. Server wide rules apply
founded 1 year ago
MODERATORS
I have one of those, ran it for a while, and one day no files. I put it on my "fix it one day" shelf. Never did figure out what happened.
Strange, I wonder if that was the SD card or one of the SATA drives? I mirror my data between the two HDDs for redundancy and occasionally run remote backups, though I've never had any problems with data loss. Been running mine for 2-3 years.
If PCI-E is a must your best bet (with least headaches) is still something x86 based, and for the lowest power you'd want something like a celeron-N or J series. For example this board: https://www.asrock.com/mb/Intel/J5040-ITX/ has sata, m2, pci-e, non-soldered RAM and will idle at ~6-7W (excluding storage). If I were doing it, though, I'd spend a few extra watts on an i3-10300 or later, which will idle at maybe 10-12W (again excluding storage) but give you much better performance and much better hardware assistance for video transcoding if you're going to be running plex/jellyfin or an OTA DVR. I use an Asus PN-41 miniPC with an i3 10300 with a couple of USB-C HDDs as an offsite backup server, and it idles right in that range plus about 5W per attached disk (when not spun down).
https://www.pine64.org/rockpro64/
If I remember I'll post the pcie card with 4x sata I use.
I've looked at this route before, but worried that it would be a headache to get everything running smoothly. What's your experience been?
Hardest part was mounting everything in my 1U chassis. Using an ATX power supply with the break out board solved a lot of problems. That way the SBC gets 12v, and the sata drives get power at the same time. And you've got connectors for fans and stuff. You can use a smaller form factor PSU. I think mine is like 200W but that's more than enough to power the board, expansion card, fans, and drives.
On the software side, I just use the Debian based distro "Armbian". But it looks like you can use others.
Hah, I haven't even started thinking about mounting problems. Awesome, thanks for this!
Well the ~~rp4~~ rp5 just came out
RP 5
Sorry, yes, that's the one