I was printing PLA, it looks ok up to a certain height (although it was warping slightly), but then it becomes ugly. I will do a test print of the same height, butaybe you already have an idea.
this post was submitted on 19 Mar 2024
15 points (94.1% liked)
3D Printing
4371 readers
1 users here now
For everyhting 3D printing related.
Please be excellent to each other :)
Icon by Freepik, Banner photo by Thiago Medeiros Araujo
founded 4 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Looks like a clog, could be caused by too much retraction, too high temp combined with too low print speeds resulting with the filament being cooked inside the nozzle.