this post was submitted on 07 Jul 2023
20 points (100.0% liked)
Australia
3595 readers
243 users here now
A place to discuss Australia and important Australian issues.
Before you post:
If you're posting anything related to:
- The Environment, post it to Aussie Environment
- Politics, post it to Australian Politics
- World News/Events, post it to World News
- A question to Australians (from outside) post it to Ask an Australian
If you're posting Australian News (not opinion or discussion pieces) post it to Australian News
Rules
This community is run under the rules of aussie.zone. In addition to those rules:
- When posting news articles use the source headline and place your commentary in a separate comment
Banner Photo
Congratulations to @Tau@aussie.zone who had the most upvoted submission to our banner photo competition
Recommended and Related Communities
Be sure to check out and subscribe to our related communities on aussie.zone:
- Australian News
- World News (from an Australian Perspective)
- Australian Politics
- Aussie Environment
- Ask an Australian
- AusFinance
- Pictures
- AusLegal
- Aussie Frugal Living
- Cars (Australia)
- Coffee
- Chat
- Aussie Zone Meta
- bapcsalesaustralia
- Food Australia
- Aussie Memes
Plus other communities for sport and major cities.
https://aussie.zone/communities
Moderation
Since Kbin doesn't show Lemmy Moderators, I'll list them here. Also note that Kbin does not distinguish moderator comments.
Additionally, we have our instance admins: @lodion@aussie.zone and @Nath@aussie.zone
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I don't think this is blackout redundancy, that would be more complicated and expensive to implement compared to just a grid-tied inverter + battery.
For this to work during blackouts it would need a very large inverter so that it can supply the entire draw of many (how many?) houses without browning out. I don't think you could fit such a thing up poles unless you install one every few poles and do lots of rewiring.
The article only makes one claim about the operation mode of the batteries:
At a guess: they're probably monitoring the line voltage and just choosing whether or not to input or output. At times of high demand (typically evenings) the 240V droops a bit low and they would start outputting to the grid. At times of high local solar supply (sunny midday) the 240V rises high and they would probably charge the battery.
Have a read about "solar voltage rise" for more info. Lots of home grid-tied solar installs have to limit their output during midday because the local network line voltage goes too high and risks blowing up appliances.
They (within limits) wouldn't need to if they used the method I detail above.
...if they installed lots of these nearby to each other then they'd have to do some modelling of the control algorithms to make sure they're stable. I'm sure someone will stuff that up at some point in order to optimise aggressiveness of charge/discharge ($ earned/saved) instead, leading to some fun news stories.
So basically with all the solar panels putting extra power into the grid, they’re already coordinating thousands of distributed systems and this is about balancing those against the actual demand.
Home-scale solar systems are typically not "coordinated" centrally. They have their own controller that chooses when and when not to export to the grid.
Yes, based of my best interpretation of the (very minimal) info given in the article.
I'm wondering if they're voltage regulators. The issue with solar is peaks and troughs - .a battery could be used to level it out.
They would have that effect. Pumping power into the local grid (depleting the battery) raises the local voltage. Pulling power out of the local grid (charging the bat) lowers the local voltage.