Ordinarily, I wouldn't turn down bacon for any reason, but in PLA it looks kinda bad. Any ideas as to cause and, more importantly, prevention?
this post was submitted on 14 Jul 2023
3 points (100.0% liked)
3D Printing
4302 readers
1 users here now
For everyhting 3D printing related.
Please be excellent to each other :)
Icon by Freepik, Banner photo by Thiago Medeiros Araujo
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Over extrusion and first layer to close to bed.
Adjust z oddest 0.05mm and see if it still happens. You might also calibrate your e steps if you still see issues.