Ordinarily, I wouldn't turn down bacon for any reason, but in PLA it looks kinda bad. Any ideas as to cause and, more importantly, prevention?
this post was submitted on 14 Jul 2023
3 points (100.0% liked)
3D Printing
4302 readers
1 users here now
For everyhting 3D printing related.
Please be excellent to each other :)
Icon by Freepik, Banner photo by Thiago Medeiros Araujo
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's a little hard to tell from your photos but it looks like your nozzle might be too close to the bed. The first layer looks thin in places and the baconing could be from the plastic being squeezed out the sides
Yeah, it can be useful to run a large 1st layer print (usually a test print) and live adjust the z axis as it's pouring the icing to get the best lines.