They came with my kegs from Kegco but I think they're limiting the beer's CO2 intake. I'm going to swap them out for traditional ones today to see if they make a difference.
I have been plagued by poor carbonation and I have tried everything else.
this post was submitted on 30 Jul 2023
9 points (90.9% liked)
Homebrewing - Beer, Mead, Wine, Cider
2195 readers
1 users here now
A community dedicated to homebrewing beer, mead, wine, cider and everything in between. If it ferments, bring it over here.
Share recipes, ideas, ask for feedback or just advice.
Some starting points for beginners:
Quick and diry guide to fermenting fruit - cider and wine
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Ok, very good to know. No dry-hopping in the keg and I transferred it to a secondary and then the keg, which removed the majority of the sediment (though it is a hazy IPA).
I'm interested to see if the dip tube is clogged as well, though.
Hmm. I would personally try blasting some CO~2~ through the liquid post to clear out any blockages.
Yeah, not removing the dip tube entirely?
Also, I would assume with a slow leak that I would find myself running out of CO2 pretty quickly, right?
I mean you could remove the dip tube but then you are opening up the beer to oxygen and potential contamination. Blasting gas through the liquid post can help clear clogs without opening up the keg. You can check for leaks by spraying the posts and the lid with either starsan or just soapy water.
Yeah, I was worried about contamination, too. I'll give your method a try. Thanks for all the advice!
For what it's worth, here's what the old post looked like.
I put the new post on and the beer immediately went up the line out. I don't think there was a clog at all. Going to leave it for a couple days to see if it makes the difference.
I don't notice anything super out of the ordinary. The poppet does appear to be more depressed than usual (they usually sit flush with the top of the post) but if anything I would think that it would be more likely to flow normally in this state (rather than not pour properly). I'm glad the new post seems to be working at least!
Yeah, we'll see if that does the trick. Thanks again!