One painful firmware update later and the z-offset bug that has plagued me since getting the Neptune 4 Pro is finally resolved and first layers are good again just like that. I just had to share the thrilling end result.
this post was submitted on 17 Aug 2024
226 points (96.7% liked)
3DPrinting
15591 readers
41 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Don't forget to swap the springs out too. At least for me my Neptune had trash springs that couldn't hold tension to save its life. I bought a cheap set on amazon and i stopped banging my head against the wall. Mind you i have the plus, so maybe not an issue for the pro.
I printed some locks for the leveling knobs to keep them in place, would new springs do the same thing?
Doesn't prevent the screw from turning necessarily. What you need is better tension.
Just ordered a pack of silicone springs as mentioned above!