this post was submitted on 05 Jul 2023
25 points (93.1% liked)

Woodworking

6146 readers
2 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is a planter box made by @Captain Aggravated, the winner of our summer '24 woodworking contest. Congratulations!

founded 1 year ago
MODERATORS
NataliePortland@lemmy.ca
25
Just upgraded, does anyone have pointers for when I unbox/setup? (lemmy.world)
submitted 1 year ago by Shartacus@lemmy.world to c/woodworking@lemmy.ca
12 comments fedilink hide all child comments
 

I know it’s only a 6” but that’s all I need right now, couldn’t justify the extra expense for the 8” at the moment.

you are viewing a single comment's thread
view the rest of the comments
[–] DavidP@toast.ooo 4 points 1 year ago (2 children)

Check the calibration:

  1. Confirm that the outfeed table is parallel to the cutter head.
  2. Confirm that the outfeed table is level with the top dead center of the cut.
  3. Then confirm that the infeed table is parallel to the outfeed
  4. Lastly confirm that the fence, when set to 90, is square to the outfeed table.

This should all the the case right out off the pallet but it's worth a check.

[–] trees@lemmy.ca 4 points 1 year ago (1 children)

Adding on to this calibration comment that an engineer square is much more accurate for setting up machines than a carpenters square (which are often knocked out of alignment).

[–] akincisor@lemmy.world 1 points 1 year ago

https://www.youtube.com/watch?v=Hg53x5W7YOc

The wood and plastic squares are super easy to adjust.